Scheduled Downtime
On Friday 21 April 2023 @ 5pm MT, this website will be down for maintenance and expected to return online the morning of 24 April 2023 at the latest

Time output is written only to rsl.error.0000 and rsl.out.0000 log files in a parallel run

This post was from a previous version of the WRF&MPAS-A Support Forum. New replies have been disabled and if you have follow up questions related to this post, then please start a new thread from the forum home page.

hconel

Member
Hi,
I'm running real.exe and wrf.exe parallel on 20 cores. The time output (that is, the lines which look like:
Code:
...
Timing for main: time 2021-11-14_00:57:52 on domain   4:    0.69735 elapsed seconds
Timing for main: time 2021-11-14_00:57:52 on domain   4:    0.70016 elapsed seconds
Timing for main: time 2021-11-14_00:57:52 on domain   3:    3.04031 elapsed seconds
Timing for main: time 2021-11-14_00:57:53 on domain   4:    0.70231 elapsed seconds
...
)
writes only to rsl.error.0000 and rsl.out.0000 files. The log files rsl.error.[0001-0019] and rsl.out.[0001-0019] does not contain such lines. I'm not quite sure, but if I remember correctly, "Timing for main: ..." lines were appearing in all of the rsl files in my previous runs.

Is this expected behavior? Am I mistaken in my recollection?

Thanks in advance.
 
Top