## Questions about time step

Topics specifically related to the wrf.exe program
chunchih
Posts: 12
Joined: Tue Sep 08, 2020 3:52 pm

### Questions about time step

Hi WRF Help,

I have a few questions about the WRF model time step.

I am running a two-way nested real-case simulation with three domains. The coarsest domain has a spatial resolution of 9 km. I set my parent_grid_ratio to = 1, 3, 3, so my two nested domains have horizontal resolutions of 3 km and 1 km respectively. However, because I also have a very fine vertical resolution in the lower levels (~20 m), I set my time step to be 12 sec. to keep my simulation numerically stable. I also set the parent_time_ step_ratio to = 1, 3, 2, so the time steps for d01, d02, d03 are 12 sec., 4 sec. and 2 sec., respectively.

My questions are:
1) Is using an even value (e.g., 2 for the third domain as described above) for the time step ratio a problem? I believe it is generally recommended to use odd ratios (3 or 5) for the parent_grid_ratio, but I read that the time step ratio can be different from the parent grid ratio. Though, I am just unsure if using an even ratio is OK.

2) I realize that the 12/4/2 seconds time steps are probably more than small enough for my domains, but in my understanding, there is no lower limit on the time step. Is this correct?

My simulation completed fine. I was just curious about the answers.

Many thanks,

David

kwerner
Posts: 2287
Joined: Wed Feb 14, 2018 9:21 pm

### Re: Questions about time step

Hi David,
Those are good questions!
1. Yes, it is okay to use an even value for the time step ratio. The reason why we recommend an odd ratio (with feedback on) for the spatial ratio is so that the center of each parent grid point will coincide with a center point of a child grid, if that makes sense. Picture a single square (parent grid cell) with 9 grids inside (3x3). There would be a center grid cell that would have a center point that would be right on top of the very center of the single parent cell. As for timing, even numbers are perfectly fine.

2. That is correct. As long as you are okay with the slowness of the simulation with a small time step, there is no problem doing it this way.
NCAR/MMM