Hello everyone! I am trying to use a single-layer urban canopy model and LCZ map in WRF4.3.3. I used the w2w program to input the LCZ information into the geo_cem.d01 file. After WPS finished running, I used mpirun-np 20 to run real and wrf. After successfully running the real program, there was a message as shown in Figure 1. When running the wrf program, it quickly ended, but there were no obvious errors. I know that the lowest model elevation in SLUCM is higher than the highest building height, so I set dzbot=53 in namglist. The attachment contains the namelist. input file and the generated rsl. error. 0000 file that I ran wrf on.
I hope someone can help me, this is very important to me.
Please any help would be much much much appreciated!
Wishing everything all the best!
Thank you!
I hope someone can help me, this is very important to me.
Please any help would be much much much appreciated!
Wishing everything all the best!
Thank you!
