Moving Nest Tickmarks do not change

This post was from a previous version of the WRF&MPAS-A Support Forum. New replies have been disabled and if you have follow up questions related to this post, then please start a new thread from the forum home page.

L

lquitian

Member
Good afternoon,

I have a Moving Nest simulation and I'm trying to display a specific variable. In this case, d01 is stationary and d02 is the one that moves following the hurricane track. I would expect that in each timestep tickmarks would change with the location of d02, but they are always the same. I enclose a gif file. You will notice that the latitude and longitude values remain unchanged.

Thanks in advance.

Best regards,
Lara
 

Attachments

  • 850ETH.gif
    850ETH.gif
    7.7 MB · Views: 549
Hi Lara,

Are you sure you are plotting d02 and not d01? If you are plotting d02 the lat/lon tickmarks should change. If you confirmed you are plotting d02 and still have the issue, please attach your script and a few output files so I can take a look at it.
 
You must log in or register to reply here.
Back
Top