I'm running a model with WRF version 4.5.2, but it can't proceed any further due to an error.
What is unusual is that if I set the domain to nesting d02, it runs normally, but if I set it to d01, the model does not run.
Also, even when set to one domain, it performs well if I change the surface and pbl schemes.
error : bl_pbl_physics - (1) YSU scheme, sf_sfclay_physics - (1) Revised MM5 Monin-Obukhov scheme (Jimenez, renamed in v3.6)
success : bl_pbl_physics - (2) Mellor-Yamada-Janjic TKE scheme, sf_sfclay_physics - (2) Monin-Obukhov (Janjic) scheme
The error displayed in rsl.out when an error occurs is as follows:
Why are TV, TG, and FIRA nan values? This shouldn't be nan, right?
If I change the selection to something else, it runs normally, so I don't think it's a problem with the input data, but how should I fix the error?
What is unusual is that if I set the domain to nesting d02, it runs normally, but if I set it to d01, the model does not run.
Also, even when set to one domain, it performs well if I change the surface and pbl schemes.
error : bl_pbl_physics - (1) YSU scheme, sf_sfclay_physics - (1) Revised MM5 Monin-Obukhov scheme (Jimenez, renamed in v3.6)
success : bl_pbl_physics - (2) Mellor-Yamada-Janjic TKE scheme, sf_sfclay_physics - (2) Monin-Obukhov (Janjic) scheme
The error displayed in rsl.out when an error occurs is as follows:
Why are TV, TG, and FIRA nan values? This shouldn't be nan, right?
If I change the selection to something else, it runs normally, so I don't think it's a problem with the input data, but how should I fix the error?