Dear Sir or Madam,
I am simulating the rapid intensification phase of Typhoon SAOLA in 2023 (from 2023082812 to 2023090300). I have set up three domains with resolutions of 12 km, 4 km, and 1.3 km and I am using a two-way nested setup, with one wrfinput file and WRF 3.9 version.
This case can run successfully without any errors. However, when I plot latent heat flux (LH) and sensible heat flux (HFX), I notice that HFX sometimes becomes entirely zero at certain times, meaning it fails to continuously generate valid HFX values. I have attached the namelist and the plots (Due to file size limitations, I've only included the plots for the first 12 hours). Thank you.
I am simulating the rapid intensification phase of Typhoon SAOLA in 2023 (from 2023082812 to 2023090300). I have set up three domains with resolutions of 12 km, 4 km, and 1.3 km and I am using a two-way nested setup, with one wrfinput file and WRF 3.9 version.
This case can run successfully without any errors. However, when I plot latent heat flux (LH) and sensible heat flux (HFX), I notice that HFX sometimes becomes entirely zero at certain times, meaning it fails to continuously generate valid HFX values. I have attached the namelist and the plots (Due to file size limitations, I've only included the plots for the first 12 hours). Thank you.
