andre.reis
New member
Dear all,
I hope you are doing well. I am encountering issues while running the WRF-Chem model on a Cray computer (XC50). Previously, I was using a different machine and everything was functioning correctly. However, upon transitioning to the Cray machine, I have noticed a problematic behavior. The model seems to be producing an excessive amount of aerosols within a short span of time. After a few hours of simulation, the aerosol concentration rises rapidly.
I am curious to know if anyone has experienced a similar situation or has any suggestions to address this issue. I am using version 3.9.1.1 of WRF with coupled chemistry.
I appreciate in advance any assistance or insights that you might be able to share.
Best regards,
I hope you are doing well. I am encountering issues while running the WRF-Chem model on a Cray computer (XC50). Previously, I was using a different machine and everything was functioning correctly. However, upon transitioning to the Cray machine, I have noticed a problematic behavior. The model seems to be producing an excessive amount of aerosols within a short span of time. After a few hours of simulation, the aerosol concentration rises rapidly.
I am curious to know if anyone has experienced a similar situation or has any suggestions to address this issue. I am using version 3.9.1.1 of WRF with coupled chemistry.
I appreciate in advance any assistance or insights that you might be able to share.
Best regards,