Segmentation fault (signal 11)

[Tianger]

An error occurs when I use the running wrf.exe
(base) root@50a2ac458b87:/workspace/work/wrf# cat wrf.log
starting wrf task 0 of 4
starting wrf task 1 of 4
starting wrf task 2 of 4
starting wrf task 3 of 4

===================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 18828 RUNNING AT 50a2ac458b87
= EXIT CODE: 139
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
===================================================================================
YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions


I've started with 32 threads all the way up to a single thread, but this issue still occurs, I've attached my wps file and input file, hoping for your help

 

[islas]

In your rsl.error.0002 file there is a CFL error. This thread (Segmentation Faults and CFL Errors) in section 4) might help.

 

[Tianger]

Thank you for your answer,
I have set the adaptive timestep as required by CFL notifications, smooth_cg_topo = .true., epssm = 0.2, w_damping = 1, adaptive_timestep set the minimum timestep 15 and the maximum 45, and still get an error.

In your rsl.error.0002 file there is a CFL error. This thread (Segmentation Faults and CFL Errors) in section 4) might help.

===================================================================================
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 18956 RUNNING AT 50a2ac458b87
= EXIT CODE: 135
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
===================================================================================
YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Bus error (signal 7)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions
Also attached is the latest run log, but it doesn't seem to find any issues, is this a problem with my computer running or a software parameter setting issue?