Using ESA land cover data in WPS

This post was from a previous version of the WRF&MPAS-A Support Forum. New replies have been disabled and if you have follow up questions related to this post, then please start a new thread from the forum home page.

N

Nafiseh

New member
I am trying to use my own land cover data in wrf which is ESA land cover products.

I followed all the steps in this website and could convert them to wps format. (https://summerinthecity.gitbooks.io/summerinthecity/content/converting-to-wrf-input.html) and geogrid.exe finishes successfully. But when I check the output my land cover domain is upside down and goes to the opposite side of my domain.
I also tried write_geogrid.c and got the same results.

Any help will be appreciated.


Nafiseh Haghtalab

PhD Candidate,

Department of Geography, Environment, and Spatial Science,

Michigan State University. [/size]
 
Nafiseh,

I am not quite sure whether all the information in the website you referred to are correct. Below is the website that you can take a look. I hope it helps for your case. Please see http://www2.mmm.ucar.edu/wrf/users/tutorial/201901/duda_wps_advanced.pdf

Would you please follow the instruction there to incorporate your data into WPS? Please let me know if you still have trouble to make it work.
 
You must log in or register to reply here.
Back
Top