WRF run error: exit code:1

[abhi24]

Hi,
I am running the model and got the following error. I have also attached the rsl error file.

= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= EXIT CODE: 1
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES

 

[islas]

The logfile at the very end states that the program "Ran out of valid boundary conditions in file wrfbdy_d01"

This old thread may be useful:

WRF runs out of boundary conditions, but at end of simulation

Problem: I set WRF to run between 2009-03-01 00:00:00 and 2009-03-02 00:00:00, however WRF starts outputting error messages at 2009-03-02 00:00:00, looking for more data to ingest. I expected the model to stop ingesting data on the final time step and end successfully, but that does not seem to...

forum.mmm.ucar.edu

There is a mismatch between the data in the boundary conditions file for domain 1 and the simulation time. This could be a namelist error or that the real.exe program did not run correctly leading to an incomplete wrfbdy_d01 file.

Could you upload the your namelist file as well as the the rsl.out.0000 of the real.exe output?

 

[abhi24]

Yes, it was useful. It was a namelist error. Thanks.