E_PV_URB3 OUTPUT OF WRFOUT

[2023xiaoli -a]

Hello, I met a problem. The following is my relevant information. I set up WRF_ SOLAR_ Diagnostics=1, but I found that the output E_ PV_ URB3 is still 0. Does anyone know what else I should change

 

[2023xiaoli -a]

Hello, I met a problem. The following is my relevant information. I set up WRF_ SOLAR_ Diagnostics=1, but I found that the output E_ PV_ URB3 is still 0. Does anyone know what else I should change

 

[Ming Chen]

In your namelist.input, you set
sf_urban_physics = 0, 0, 3,

Can you change it to
sf_urban_physics = 3, 3, 3,

Then try again?

Also, did you run WRF-ARW or WRF-SOLAR?

 

[2023xiaoli -a]

In your namelist.input, you set
sf_urban_physics = 0, 0, 3,

Can you change it to
sf_urban_physics = 3, 3, 3,

Then try again?

Also, did you run WRF-ARW or WRF-SOLAR?

Thank you for your reply. I have set sf_ urban_ Physics=3, 3, 3 before. In the&diags module, according to the readme Input and WRF_ SOLAR is set on SOLAR's official website.The WRF has been activated since the solar_diagnostics option. I'm not familiar with this option. Did wrf activate wrf_solar, it is said that only when it is activated will E_ PV_ URB3 or this parameter need other values to activate