IEEE error after metgrid.exe

This post was from a previous version of the WRF&MPAS-A Support Forum. New replies have been disabled and if you have follow up questions related to this post, then please start a new thread from the forum home page.

S

sachin

New member
ALL geogrid.exe, ungrib.exe and metgrid.exe ran successfully but after metgrid.exe I got the following IEEE note.
! Successful completion of metgrid. !
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Note: The following floating-point exceptions are signalling: IEEE_OVERFLOW_FLAG IEEE_UNDERFLOW_FLAG IEEE_DENORMAL

Is there any problem in WPS or is it normal.
Is there will be any bad effect of this in wrf run.
 
Hi,
This should not be a problem. This message prints out with certain compilers, and was originally put in the code for testing purposes. You should be perfectly fine to continue to run real and wrf.
 
You must log in or register to reply here.
Back
Top