Hello, everyone. I am running WPS4.6.0. I have 3 domains, and when I run Metgrid, it is successfully completed. However, Metgrid provides output for every 3 hours of data for my first domain. When it comes to domains 2 and 3, only data for the first hour is provided, not all hours. Is this correct?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
metgrid.exe output files
- Thread starter sadeghnn
- Start date
THanks kwerner.yes they are the same.would you please explain its reason for meIf you set the end date/time to the same as the start date/time for domains 2 and 3 in namelist.wps, then yes, this is correct.
If you have, for example, the following settings:
metgrid is going to output a file, for each domain, at the initial time (start_date), and then every 3 hours (based on the interval_seconds set to 10,800 - 3 hours) through the end_date. So you should get five files for d01 because the start/end dates have a range of 12 hours. But because d02 has an end_date set to the same/initial time at the start_date, it will only output at the initial time.
This type of setting is okay, as long as you aren't planning to use sst_update or any sort of nudging during WRF.
Code:
start_date = '2019-09-04_12:00:00','2019-09-04_12:00:00',
end_date = '2019-09-05_00:00:00','2019-09-04_12:00:00',
interval_seconds = 10800metgrid is going to output a file, for each domain, at the initial time (start_date), and then every 3 hours (based on the interval_seconds set to 10,800 - 3 hours) through the end_date. So you should get five files for d01 because the start/end dates have a range of 12 hours. But because d02 has an end_date set to the same/initial time at the start_date, it will only output at the initial time.
This type of setting is okay, as long as you aren't planning to use sst_update or any sort of nudging during WRF.
Hi KWERNR. I run the wrf i have found error. would you please help me to find what the problem is? I run geogrid,ungrib,metgrib,real and now in wrf running I faced problem. I attached my error file and namelists.
WPS4.6.0, WRF 4.5.2.
My domain is 3000x3000m.My data resolution is 0.25 degree NECP GFS
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 26155 RUNNING AT SOCE-Y71831
= EXIT CODE: 9
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
===================================================================================
YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions
WPS4.6.0, WRF 4.5.2.
My domain is 3000x3000m.My data resolution is 0.25 degree NECP GFS
= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES
= PID 26155 RUNNING AT SOCE-Y71831
= EXIT CODE: 9
= CLEANING UP REMAINING PROCESSES
= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES
===================================================================================
YOUR APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)
This typically refers to a problem with your application.
Please see the FAQ page for debugging suggestions
Attachments
Last edited: