hamzanisar470
New member
I am trying to run BEM/BEP but values for TGR_URB4D are always 0.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
TGR_URB4D Value is always 0
- Thread starter hamzanisar470
- Start date
hamzanisar470
New member
I ran this on versions 4.3.3 and 4.5.2. kindly find the attached fileWhich version of WRF did you run?
Please send me your namelist.input to take a look.
Attachments
hamzanisar470
New member
EP_PV_URB3D
QGR_URB4D
TGR_URB4D
DRAINGR_URB3D
I have these 4 parameters and all have 0 Value
QGR_URB4D
TGR_URB4D
DRAINGR_URB3D
I have these 4 parameters and all have 0 Value
QGR_URB4D and TGR_URB4D are never calculated in the codes. This is why you see their values are zero.
However, DRAINGR_URB3D and EP_PV_URB3D should have non-zero values. For your case, did you have precipitation at the urban grids where you look at DRAINGR_URB3D? How about EP_PV_URB3D at daytime?
However, DRAINGR_URB3D and EP_PV_URB3D should have non-zero values. For your case, did you have precipitation at the urban grids where you look at DRAINGR_URB3D? How about EP_PV_URB3D at daytime?
hamzanisar470
New member
Yes, I have checked again all values are zero even at day time.
I am using Copernicus Climate Data Store | Copernicus Climate Data Store as a data input, but I downloaded the data specific sub region instead of whole global data. does it make any differnce ?
Also i am using CGLC data set.
I am using Copernicus Climate Data Store | Copernicus Climate Data Store as a data input, but I downloaded the data specific sub region instead of whole global data. does it make any differnce ?
Also i am using CGLC data set.